CHASSIS 6-65
REMOUNTING
Remounting the rear shock absorber in the reverse order of
removal. Pay attention to the following points:
• Tigten each bolt/nut to the specified torque.
# Rear shock absorber nut (Upper)
1:
60 N·m (6.0 kgf-m, 43.5 lb-ft)
Rear shock absorber nut (Lower)
2:
55 N·m (5.5 kgf-m, 40.0 lb-ft)
Rear cushion rod nut
3: 78 N·m (7.8 kgf-m, 56.5 lb-ft)
SUSPENSION SETTING
SPRING PRE-LOAD ADJUSTMENT
The rear suspension spring pre-load is adjustable. This adjust-
ment is performed by changing spring set length.
SPRING SET LENGTH
%
• Remove the rear shock absorber. (!6-62)
• Loosen the locknut
1.
• Adjust the spring set length by turning the adjuster
2.
• Tighten the locknut
1 to the specified torque.
# Rear shock absorber locknut:
88 N·m (8.8 kgf-m, 63.5 lb-ft)
• Remount the rear shock absorber. (!above)
STANDARD
MAXIMUM
(SOFTEST)
MINIMUM
(STIFFEST)
233 mm
( 9.17 in)
238 mm
( 9.37 in)
228.5 mm
( 9.00 in)
Do not set the spring length out of the specified range.
To Next Page
Loading...
