Suzuki LT-Z400 - Inspection and Disassembly

CHASSIS 6-11
REAR WHEEL HUB
• Remove the rear wheel. (!6-10)
• Remove the cotter pin and loosen the wheel hub nut by apply-
ing the rear brake.
• Remove the wheel hub nut and washer.
• Remove the wheel hub
1.
INSPECTION AND DISASSEMBLY
DUST SEAL
Inspect the dust seal lips for wear or damege.
If any damages are found, replace the dust seal with a new one.
• Remove the dust seals with the special tool.
& 09913-50121: Oil seal remover
%
HUB BEARINGS
Inspect the inner race play of the hub bearing by hand while it is
in the wheel hub.
Rotate the inner race by hand to inspect for abnormal noise and
smooth rotation. If there is anything unusual, replace the bearing
with a new one.
• Remove the hub bearing with the special tool.
& 09921-20240: Bearing remover set
%
Replace the removed dust seal with a new one.
Do not reuse the removed bearings.