PERIODIC MAINTENANCE 2-13
OIL FILTER REPLACEMENT
• Drain the engine oil as described in the engine oil replace-
ment procedure.
• Remove the oil filter cap
1 and oil filter
2.
• Replace the oil filter with a new one.
• Install the new O-ring
3.
• Install the spring
4 and new O-ring
5.
!
• Replace the oil filter cap and tighten the nut securely.
NOTE:
Face the triangle mark
A on the cap upward.
• Add new engine oil and check the oil level as described in the
engine oil replacement procedure.
% Engine oil capacity
Oil change: 2.0 L (2.1 US qt, 1.8 lmp qt)
Oil and filter change: 2.1 L (2.2 US qt, 1.8 lmp qt)
Engine overhaul: 2.2 L (2.3 US qt, 1.9 lmp qt)
!
ENGINE OIL HOSES
Inspect the engine oil hoses for damage and oil leakage. If any
damages are found, replace the engine oil hoses with new ones.
Apply engine oil to the O-rings.
When reassembling the oil filter, make sure that the oil
filter is installed as shown above. If the filter is
installed improperly, serious engine damage may
result.
Inspect initially at 1 month and every 3 months there-
after.
To Next Page
Loading...
