2-16 PERIODIC MAINTENANCE
CLUTCH
• Loosen the locknut
1.
• Turn the adjuster
2 in or out to obtain the correct play.
• Tighten the locknut
1.
% Clutch lever play
A: 10 – 15 mm (0.4 – 0.6 in)
BRAKES
BRAKE PADS
• Remove the front and rear wheels. (#6-10)
The extent of brake pad wear can be checked by observing the
limit line
1 on the side of brake pads. When the wear reaches the
limit line, replace the pads with new ones. (#6-18 and 6-50)
!
" Brake pad mounting pin (front and rear):
18 N·m (1.8 kgf-m, 13.0 lb-ft)
REAR BRAKE PEDAL AND LEVER
The procedure for adjusting the rear brake pedal and brake
lever is as follows:
NOTE:
First adjust the brake pedal, and then adjust the brake lever.
Brake pedal
• Turn the adjuster
1 in or out until the pedal height
A to the
specification, after loosening the locknut
2.
• Make sure to tighten the locknut
2 securely.
% Brake pedal height
A
AA
A: 0 – 10 mm (0 – 0.4 in)
" Rear brake master cylinder rod locknut:
18 N·m (1.8 kgf-m, 13.0 lb-ft)
Inspect initially at 1 month and every 6 months there-
after.
Inspect initially at 1 month and every 3 months there-
after.
Replace the brake pads as a set, otherwise braking
performance will be adversely affected.
To Next Page
Loading...
