Suzuki LT-Z400 - Remounting

4-14 FUEL SYSTEM
VALVE SEAT
• Install the valve seat
1 into the carburetor body, and then
tighten the screw
2.
NOTE:
Make sure that the collar of the screw
2 holds the step of the
valve seat
1 securely.
DIAPHRAGM
• Install the diaphragm assembly and O-ring
1.
NOTE:
When installing the diaphragm, make sure the diaphragm is
seated at the concave section of the carburetor.
#
THROTTLE STOP SCREW
• Apply SUZUKI SUPER GREASE “A” to thread part of the
throttle stop screw, then install the throttle stop screw to the
carburetor.
& 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
REMOUNTING
Remount the carburetor assembly in the reverse order of
removal. Pay attention to the following points:
• Align the lug on the carburetor with the intake pipe’s cutout.
• Connect the carburetor hoses properly. (!8-15)
After the carburetor assembly has been remounted onto the
engine, perform the following adjustments:
* Throttle cable play ........................................ !2-11
* Engine idle speed ......................................... !2-11
Replace the removed O-ring with a new one.