CHASSIS 6-43
• Install the steering shaft bushing
1 with the special tool.
& 09924-84510: Bearing installer set
REASSEMBLY AND REMOUNTING
Reassemble and remount the steering sfaft in the reverse order
of removal and disassembly. Pay attention to the following
points:
STEERING SHAFT
• Apply SUZUKI SUPER GREASE “A” to the O-ring, dust seals
and steering shaft before remounting the steering shaft.
' 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
• Install the dust seal
1 to the steering shaft.
• Install the new O-ring
2 and dust seal to the steering shaft.
• Tighten the steering shaft nut to the specified torque.
# Steering shaft nut: 49 N·m (4.9 kgf-m, 35.5 lb-ft)
• Install the cotter pin.
%
Replace the removed cotter pin with a new one.
To Next Page
Loading...
