ENGINE 3-49
CRANKCASE
• Thoroughly remove the sealant material and oil stains on the
mating surface of the right and left crankcases.
• Install the dowel pins
1 to the left crankcase.
• Apply engine oil to the conrod big end and to the transmission
gears.
• Apply SUZUKI BOND “1207B” or “1215” to the mating surface
of the right crankcase as shown.
* 99104-31140: SUZUKI BOND “1207B” (USA)
+ 99000-31110: SUZUKI BOND “1215” (Others)
• Tighten the crankcase bolts to the specified torque.
# Crankcase bolt: 11 N·m (1.1 kgf-m, 8.0 lb-ft)
To Next Page
Loading...
