3-34 ENGINE
BALANCER SHAFT AND BALANCER DRIVEN GEAR
DISASSEMBLY
• Disassemble the balancer shaft as shown in the illustration.
INSPECTION
Inspect the balancer shaft and balancer driven gear for wear or
damage. If any wear or damage is found, replace the defective
part.
Measure the free length of each balancer spring. If any spring
length is less than the service limit, replace all of the spring.
& 09900-20101:Vernier calipers
Service Limit: 10.3 mm (0.41 in)
REASSEMBLY
Reassemble the balancer driven gear in the reverse order of dis-
assembly.
• Install the balancer driven gear by aligning the matching
marks.
A: Pin
1
Balancer shaft
2
Pin
3
Balancer driven gear
4
Spring (4 pcs.)
5
Pin (2 pcs.)
To Next Page
Loading...
