Suzuki LT-Z400 - Starter Torque Limiter; Oil Pump

3-36 ENGINE
STARTER TORQUE LIMITER
"
Check the slip torque of the starter torque limiter using the spe-
cial tools and vise as shown, if the slip torque is not within the
specified torque, replace the starter torque limiter with a new
one.
& 09930-73170: Starter torque limiter holder
09930-73180: Starter torque limiter socket
# Slip torque:
30 – 55 N·m (3.0 – 5.5 kgf-m, 21.5 – 40.0 lb-ft)
OIL PUMP
• Remove the outer rotor
1, inner rotor 2 and pin 4.
Inspect the outer rotor
1 and inner rotor 2 for any scraches or
other damage. If any damages are found, replace them with new
ones.
"
$ 99000-32030: THREAD LOCK SUPER “1303”
• Apply engine oil to the sliding surfaces of the oil pump inner
rotor, outer rotor and shaft.
• When installing the inner rotor
2, align the pin 4 with the
groove
5.
Do not attempt to disassemble the starter torque lim-
iter. It is unserviceable.
The oil pump case securing screw
3 is applied with
SUZUKI THREAD LOCK SUPER “1303”. If an attempt
is made to overhaul the oil pump assembly, the screw
may be damaged. Only the oil pump unit is available
as a replacement.