6-60 CHASSIS
• Remove the connector
7 and O-ring
8 by removing the snap
ring
9.
• Remove the dust boot
0.
• Remove the snap ring
A.
• Remove the push rod
B, piston/primary cup
C and spring
D.
MASTER CYLINDER INSPECTION
MASTER CYLINDER
Inspect the master cylinder bore for any scratches or damage. If
any damages are found, replace the master cylinder with a new
one.
PISTON AND RUBBER PARTS
Inspect the piston surface, primary cup, secondary cup and dust
boot for any scratches, wear or damage. If any damages are
found, replace them with a new one.
To Next Page
Loading...
