Suzuki LT-Z400 - Reassembly and Remounting

CHASSIS 6-83
REASSEMBLY AND REMOUNTING
Reassemble the rear axle shaft and rear axle housing in the
reverse order of removal and disassembly. Pay attention to the
following points:
REAR SPROKET
• Install the rear sprocket
1 to the sprocket flange 2.
• Apply THREAD LOCK SUPER “1303” or “1322” to the
sprocket mounting bolts.
- 99000-32030: THREAD LOCK SUPER “1303” (USA)
$ 99000-32110: THREAD LOCK SUPER “1322” (Others)
• Tighten the sprocket mounting bolts to the specified torque.
# Sprocket mounting bolt: 54 N·m (5.4 kgf-m, 39.0 lb-ft)
NOTE:
* The concave side of washer
3 must face to the sprocket.
* The stamped mark
4 must face to left of the vehicle.
AXLE HOUSING
• Apply SUZUKI SUPER GREASE “A” to the bearings and dust
seals before installing.
' 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)