CHASSIS 6-15
TIRES
TIRE REPLACEMENT
• Remove the front and rear wheels. (!6-10)
• After removing the air valve cap, release the tire pressure by
depressing the valve.
• Dismount the bead from the rim completely as shown.
• Separate the tire from the rim by using a set of tire levers and
rim protectors.
%
• Inspect the sealing portion of the rim for contamination and
distortion. If any damages are found, replace the rim with a
new one.
• Clear up the sealing portion of the rim.
• Apply tire lubricant to the tire bead and the flange of the rim.
%
%
• Mount the tire on the rim.
When using the tire lever, do not scratch or hit the
sealing portion (hump) of the wheel or it may cause
air-leakage.
Never apply grease, oil or gasoline to the tire bead
because they will deteriorate the tire.
The standard tire fitted on this vehicle is
AT22×7R10✩✩
✩✩✩✩
✩✩ for the front and AT20×10R9✩✩
✩✩✩✩
✩✩ for the
rear.
The use of tires other than the standard may cause
instability. It is highly recommended to use the speci-
fied tire.
To Next Page
Loading...
