6-14 CHASSIS
REAR WHEEL HUB
• Apply small amount of SUZUKI SUPER GREASE “A” to the
wheel hub’s spline.
' 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
• Install the rear wheel hub
1, washer and nut.
• Tighten the rear wheel hub nut to the specified torque.
# Rear wheel hub nut: 100 N·m (10.0 kgf-m, 72.5 lb-ft)
• Install the cotter pin into the rear axle.
• Install the rear wheel. (!below)
%
FRONT WHEEL
• Install the hub plate
1.
• Install the front wheel.
• Tighten the wheel set nuts to the specified torque.
# Wheel set nut: 50 N·m (5.0 kgf-m, 36.0 lb-ft)
NOTE:
When installing the front wheel, make sure that the arrow
A on
the tire points in the direction of rotation.
REAR WHEEL
• Install the rear wheel.
• Tighten the wheel set nuts to the specified torque.
# Wheel set nut: 50 N·m (5.0 kgf-m, 36.0 lb-ft)
NOTE:
When installing the rear wheel, make sure that the instruction
“SIDE FACING OUTWARDS”
B on the rear tire faces outwards.
Replace the removed cotter pin with a new one.
To Next Page
Loading...
