7-8 ELECTRICAL SYSTEM
INSPECTION
BATTERY CURRENT LEAKAGE
• Remove the seat. (! 6-4)
• Turn the ignition switch to the “OFF” position.
• Disconnect the
- battery lead wire.
Measure the current between
- battery terminal and the
- bat-
tery lead wire using the multi circuit tester. If the reading
exceeds the specified value, leakage is evident.
# 09900-25008: Multi circuit tester set
$ Tester knob indication: Current (%, 20 mA)
& Battery current (leak): Under 1.0 mA
"
When checking to find the excessive current leakage, remove
the couplers and connectors, one by one, checking each part.
NOTE:
When removing the
+ battery lead wire release the hook of
clamp.
* Because the current leak might be large, turn the
tester to the high range first to avoid tester damage.
* Do not turn the ignition switch to the “ON” position
when measuring current.
To Next Page
Loading...
