6-92 CHASSIS
• Remove the engine sprocket cover. (!3-5)
• Disconnect the cable by removing the cable mounting bolt.
REMOUNTING
Remount the reverse lock release cable in the reverse order
removal. Pay attention to the following points:
• Install the spring with the spring end
A matched the groove
B on the housing.
• Apply SUZUKI SUPER GREASE “A” to the O-ring
1.
' 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
• Install the O-ring
1 to the reverse lock release cable
2.
• Connect the cable to the rotor
3 through the hole of the hous-
ing.
NOTE:
* When installing the rotor, hook the spring end
C on the con-
cave portion
D of the rotor.
* Make sure that the reverse lock release cable is routed cor-
rectly.
To Next Page
Loading...
