6-74 CHASSIS
REASSEMBLY
Reassemble the cushion lever, cushion rod and swingarm in the
reverse order of disassembly and removal. Pay attention to the
following points:
SWINGARM BEARING AND DUST SEAL
• Press the bearing into the swingarm pivot with special tool to
the depth of 5 mm (0.2 in). (!6-75)
& 09924-84510: Bearing installer set
• Press the bushing into the swingarm pivot with special tool to
the depth of 12 mm (0.47 in). (!6-75)
• Install the dust seals into the swingarm pivot with the stamped
mark showed up.
• Apply SUZUKI SUPER GREASE “A” to the bearings, bush-
ings and lips of dust seal.
' 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
• Apply SUZUKI SUPER GREASE “A” to lip of the dust covers
1.
• Install the dust covers
1, washers
2 and spacers
3 to the
swingarm.
' 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
To Next Page
Loading...
