Suzuki LT-Z400 - Gearshift Cam, Fork and Reverse Lock Shaft

3-48 ENGINE
GEARSHIFT CAM, FORK AND REVERSE LOCK SHAFT
• Install the gearshift forks into the gearshifting grooves in the
correct position and direction.
1 Gearshift fork No.1
2 Gearshift fork No.2
3 Gearshift fork No.3
• Install the gearshift cam
4.
• Install the gearshift fork shaft
5 and reverse lock shaft 6.
NOTE:
* After the gearshift fork shaft and gearshift forks have been fit-
ted, make sure that the gears engage normally.
* Set the transmission gears to the neutral position.
1 Gearshift fork No.1
2 Gearshift fork No.2
3 Gearshift fork shaft
4 Pin
5 Gearshift cam
6 Gearshift fork No.3
7 Reverse lock shaft
8 Spring