6-36 CHASSIS
• Tighten the tie rod end nut to the specified torque.
# Tie rod end nut: 60 N·m (6.0 kgf-m, 43.5 lb-ft)
• Install the cotter pin.
%
NOTE:
When installing the tie rod end, install the washer
0 between
the tie rod end
A and steering knuckle
B.
SUSPENSION SETTING
SPRING PRE-LOAD ADJUSTMENT
The front suspension spring preload is adjustable. The adjust-
ment can be performed by changing the ring
1 position with the
adjuster tool. Position 1 provides the softest spring pre-load and
position 5 provides the stiffest. The spring preload is set on posi-
tion 3 at the factory.
STD POSITION: 3
)
Replace the removed cotter pin with a new one.
Unequal suspension adjustment can cause poor han-
dling and loss of stability. Adjust the right and left
shock absorbers to the same setting.
1
2
3
4
5
To Next Page
Loading...
