COOLING AND LUBRICATION SYSTEM 5-7
COOLING FAN
INSPECTION
• Remove the front fender. (%6-4)
• Disconnect the cooling fan lead wire coupler.
Test the cooling fan motor for load current with an ammeter con-
nected as shown in the illustration.
The voltmeter is for making sure that the battery applies 12 volts
to the motor. With the motor with electric motor fan running at
full speed, the ammeter should be indicating not more than 5
amperes.
If the fan motor does not turn, replace the motor assembly with a
new one.
NOTE:
When making above test, it is not necessary to remove the cool-
ing fan.
REMOVAL
• Remove the front fender. (%6-4)
• Disconnect the coolant temperature switch lead wire coupler
1 and the cooling fan motor lead wire coupler
2 and the
cooling fan thermo-switch lead wire coupler
3.
• Remove the three mounting bolts and the cooling fan unit.
Fan motor Ammeter
Battery
To Next Page
Loading...
