ENGINE 3-53
OIL PUMP
• Before mounting the oil pump, apply engine oil to the sliding
surfaces of the oil pump case, outer rotor, inner rotor, and
crankcase.
• Apply a small quantity of THREAD LOCK “1342” or THREAD
LOCK SUPER “1322” to the oil pump mounting screws, and
then tighten them securely.
( 99000-32050: THREAD LOCK “1342” (USA)
, 99000-32110: THREAD LOCK SUPER “1322” (Others)
• When installing the oil pump driven gear, align the pin
1 with
the groove
2.
CAM CHAIN
• Install the cam chain
1 onto the sprocket.
• Tighten the cam chain tensioner mounting bolt
2 to the spec-
ified torque.
# Cam chain tensioner mounting bolt:
10 N·m (1.0 kgf-m, 7.0 lb-ft)
OIL PIPE
• Apply engine oil to the O-rings.
• Tighten the oil pipe bolt securely.
To Next Page
Loading...
