Suzuki LT-Z400 - Page 136

COOLING AND LUBRICATION SYSTEM 5-15
• Remove the water pump cover.
• Remove the snap ring
1, water pump driven gear 2, pin 3
and washer
4.
• Remove the E-ring
5, impeller 6, and water pump body 7.
• Remove the bearing using the special tool.
& 09921-20240: Bearing remover set
NOTE:
If there is no abnormal noise, bearing removal is not necessary.
!
• Remove the mechanical seal using the special tool.
& 09921-20240: Bearing remover set
NOTE:
If there is no abnormal condition, the mechanical seal removal is
not necessary.
!
The removed bearing must be replaced with a new
one.
The removed mechanical seal must be replaced with a
new one.