CHASSIS 6-23
• Apply SUZUKI SILICONE GREASE to the brake caliper
holder slide pin.
+ 99000-25100: SUZUKI SILICONE GREASE
• Install the pin
1, washer
2 and caliper holder
3 to the cali-
per.
• Apply THREAD LOCK SUPER “1360” to the pin
1.
, 99000-32130: THREAD LOCK SUPER “1360”
• Tighten the pin
1 to the specified torque.
# Caliper holder slide pin: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
• Install the pads and spring to the caliper.
• Tighten the brake pad mounting pins
4, brake caliper mount-
ing bolts
5 and brake hose union bolt
6 to the specified
torque.
# Brake pad mounting pin: 18 N·m (1.8 kgf-m, 13.0 lb-ft)
Brake caliper mounting bolt:
26 N·m (2.6 kgf-m, 19.0 lb-ft)
Brake hose union bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
NOTE:
Before remounting the brake caliper, push the brake caliper pis-
tons all the way into the caliper.
%
Bleed air from the system after reassembling the
brake caliper. (!2-19)
To Next Page
Loading...
