Suzuki LT-Z400 - Page 200

CHASSIS 6-53
• Loosen the caliper holder slide pin
7, and then remove the
caliper holder
8.
• Remove the caliper holder slide pin
9.
• Place a rag over the brake caliper piston to prevent the piston
from popping out.
• Force out the piston by pushing the piston pin
B.
• Remove the dust seal
0, piston seal A and O-ring B.
%
* Do not reuse the dust seal, piston seal and O-ring to
prepent leakage of brake fluid.
* Do not attempt to remove the retainer
C.
Caliper