Suzuki LT-Z400 - Page 218

CHASSIS 6-71
SWINGARM BEARING AND BUSHING
Insert the spacer
1 into the bearing 2, bushing 3 and then
check the play when moving the spacer up and down.
If excessive play is noted, replace the bearing and bushing with
a new one.
• Remove the dust seals.
• Remove the pivot bearings with special tools.
& 09923-74511: Bearing remover
09930-30104: Sliding shaft
%
• Remove the pivot bushing with special tool.
& 09913-70210: Bearing installer set
%
The removed bearings must be replaced with new
ones.
The removed bushings must be replaced with new
ones.