Suzuki LT-Z400 - Page 223

6-76 CHASSIS
CUSHION ROD/LEVER BEARING AND DUST SEAL
• Install the bearings into the cushion rod/lever with the special
tool to the specified depth shown in the illustration below.
& 09924-84510: Bearing installer set
• Install the dust seals into the cushion rod/lever.
• Apply SUZUKI SUPER GREASE “A” to the bearings and lips
of dust seal.
' 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
NOTE:
* The stamped mark of dust seal must face outside.
* Refer to 6-78 for the grease nipple installation.
4.5 mm (0.18 in)
4.5 mm (0.18 in)
4 mm (0.16 in)
4 mm (0.16 in)
4.5 mm (0.18 in)4.5 mm (0.18 in)
4 mm (0.16 in)
Cushion lever
Cushion rod