ELECTRICAL SYSTEM 7-21
• Shift the transmission to the neutral position, turn the ignition
switch to the “ON” position.
• Press the starter button and allow the engine to turn for a few
seconds, and then measure the pickup coil and signal coil
peak voltage.
• Repeat the above procedure a few times and measure the
highest pickup coil and signal coil peak voltage.
( Tester knob indication: Voltage (%)
& Pickup coil peak voltage: More than 2.0 V
Signal coil peak voltage: More than 0.1 V
PICKUP COIL AND SIGNAL COIL RESISTANCE
• Disconnect the generator coupler
1.
Measure the resistance between the lead wires using the multi
circuit tester. If the resistance is not within the spcified value, the
pickup coil and signal coil must be replaced.
# 09900-25008: Multi circuit tester set
( Tester knob indication: Resistance (Ω
ΩΩ
Ω)
& Pickup coil resistance: 350 – 670 Ω
ΩΩ
Ω (Blue – Green)
Signal coil resistance: 0.09 – 0.5 Ω
ΩΩ
Ω (Black – White)
BI
B
W
Generator
Peak volt adaptor
+
-
Signal coil
G
To Next Page
Loading...
