3-8 ENGINE
• Install the engine sprocket with drive chain after loosening the
chain adjuster bolts.
NOTE:
The letter
A on the engine sprocket should face to the outside.
• Apply THREAD LOCK SUPER “1303” to the sprocket bolts.
$ 99000-32030: THREAD LOCK SUPER “1303”
• Tighten the engine sprocket bolts to the specified torque.
# Engine sprocket bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
• Install the engine coolant hose. (!8-18)
• Install the spacer
1 with O-ring to the engine oil outlet pipe.
• Tighten the engine oil outlet pipe bolt
2 securely.
• Tighten the engine oil inlet pipe union bolt to the specified
torque.
# Inlet pipe union bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
• After installing the engine, route the wiring harness, cables
and hoses properly. (!8-11 to 8-18)
• Adjust the following items.
* Engine oil !2-12
% Engine oil capacity
Oil change: 2 000 ml (2.1/1.8 US/lmp qt)
Oil and filter change: 2 100 ml (2.2/1.8 US/lmp qt)
Engine overhaul: 2 200 ml (2.3/1.9 US/lmp qt)
* Adjust the drive chain slack !2-22
* Throttle cable play !2-11
* Engine idle speed !2-11
* Clutch cable play !2-16
To Next Page
Loading...
