ENGINE 3-55
• Bend the tongue of the washer securely.
• Insert the clutch drive plates and driven plates one by one into
the clutch sleeve hub in the prescribed order.
NOTE:
* Be sure to install the drive plate with an inside diameter of
122.5 mm (4.82 in), first.
* Two different types of drive plates are used: one with an inside
diameter of 122.5 mm (4.82 in) and seven with an inside diam-
eter of 116 mm (4.5 in). For further information refer to page
3-54.
• Tighten the clutch spring set bolts securely in diagonal
stages.
• Install the dowel pins
1 and new gasket
2.
"
• Tighten the clutch cover bolts securely.
NOTE:
Install the new gasket onto the clutch cover bolt
A as shown.
Use a new gasket to prevent oil leakage.
To Next Page
Loading...
