Svantek SV 971A - Page 182

SV 971A User Manual – Appendixes
182
4 - Dosimeter
102 - 1/1 Octave & Dosimeter,
103 - 1/3 Octave & Dosimeter,
8 - RT60
19 - STIPA
4
MeasureInput
measurement input type:
2 - Microphone
5
Range
measurement range:
1 - Low
2 - Normal
6
UnitFlags
calibration flags:
b0 - if set to 1: calibration coefficient is used
b3 - if set to 1: overload occurred
b7,b6,b5: type of the result Lden
000 – Lden result is not available
001 – Ld result
010 – Le result
011 – Lde result
100 – Ln result
101 – Lnd result
110 – Len result
111 – Lden result
B9 - if set to 1: preamplifier disconnected
7
RepCycle
repetition cycle:
0 - infinity
nnnn - number of repetitions (1  1000)
8
NofChannel
number of channels (1)
8
NofProf
number of profiles (3)
10
StartDelay
start delay time
11..12
IntTimeSec
integration time specified in seconds
13
InterfaceMode
user interface mode:
0 - Start/Stop,
1 - Simple,
2 - Advanced
14
LeqInt
detector's type in the Leq function:
0 - Linear,
1 - Exponential
15
SpectrumFilter
1/1 or 1/3 Octave analysis filter:
1 - Z,
2 - A,
3 - C
5 - B
in other cases:
Reserved
16
SpectrumBuff
1/1 or 1/3 Octave logger:
sum of the following flags:
1 - logger with Lpeak values
8 - logger with Leq values
in other cases:
reserved
17
ExposureTime
exposure time: 1..720 (min)