To this chapter contents
11. A.C. GENERATOR/STARTING CLUTCH
Remove the water pump cover.
11-9
Install the right crankcase cover onto the
crankcase.
Note: Align the water pump shaft indent with the oil
pump shaft.
Assemble the connector bolt and starter pulley on
the right crankcase cover.
Assembly 12 bolts on the right case cover.
Install the water pump cover (5 bolts)
Assemble the gasket.
Assemble the starter cover on the right crankcase
cover.
Connector bolt and starter pulley
5 bolts
5 bolts
To Next Page
Loading...
