7. CYLINDER/PISTON
To this chapter contents
Clean up all residues and foreign materials on
the contact surface of crankcase. Pay attention to
not let these residues and foreign materials fall
into crankcase.
Caution
Wet the residues into solvent so that the residues
can be removed more easily.
Piston Installation
Install the piston and piston pin, and place the IN
marks on the piston topside forward to inlet valve.
Install new piston pin clip.
Caution
Do not let the opening of piston pin clip align
with the piston cutout.
Place a piece of cloth between piston and
crankcase in order to prevent snap ring from
falling into crankcase during servicing.
Cylinder Installation
Install dowel pins and new gasket.
IN mark
Clip end gap
Dowel pins
Cutout
7-7
To Next Page
Loading...
