Sym Quad Lander 600 - Steering Shaft

16. STEERING / FRONT SUSPENSION
16-4
Remove the handle mounting bolt, and then
remove the handle upper holder, handle.
Remove 2 nuts to remove handle under holder
and meter bracket.
Installation
Install in the reverse order of removal procedures.
Torque value:
Handlebar under holder nut 4.0kgf-m
Handlebar upper holder bolt 2.4kgf-m
Steering Shaft
Remove
Remove cotter pins, and loosen right and left
steering tie-rod nuts.
Remove tie-rod.
Remove cotter pins, and loosen handle Steering
shaft nut
.
4
To this chapter contents
2
2
p
in
Steerin
g
shaft