17. REAR BRAKE & REAR WHEEL & REAR CUSHION
17-11
Disk Brake System Inspection
Inspection
By visual examination whether divulges or the
damage, with spanner inspection brake tube seam
whether becomes less crowded, and the
inspection handle bar turn right or turn left, or
pressure the cushion, whether besides the
pipeline protection department, whether there is
interferes, contacts other parts.
Check the brake from behind the brake caliper.
The brake pad must be replaced with new lining
when the brake pad wear limit reaches the brake
disk.
Caution
! Before checking the rear brake lining, remove
rear wheel first.
Park the ATV on a level ground, and check if fluid
level is under the “LOWER” mark.
Recommended Brake Fluid: WELL-RUN BRAKE
OIL (DOT 3).
Caution
! When the vehicle is inclined or just stopped, the
oil level could not be accurate, settle it for the
3~5 minutes.
! In order to prevent the chemical change, please
do not use counterfeiting or other unclear
trademarks brake fluid.
! Use the same trademark brake fluid to
guarantee the braking efficiency.
Brake lining wears
limit grooves
Brake disk
To this chapter contents
To Next Page
Loading...
