2. MAINTENANCE INFORMATION
2-1
Precautions in Operation···················· 2-1
Periodical Maintenance Schedule······ 2-2
Fuel Lines············································· 2-3
Acceleration Operation ······················· 2-3
Air Cleaner············································ 2-3
Spark Plug············································ 2-4
Valve Clearance ··································· 2-4
Carburetor Idle Speed Adjustment····· 2-5
Ignition System···································· 2-6
Cylinder Compression Pressure ········ 2-6
Drive Belt·············································· 2-7
Propeller Shaft ····································· 2-7
Front Differential·································· 2-8
Rear Axle Gearbox······························· 2-8
Brake System ······································· 2-9
Brake Light Switch······························· 2-10
Headlight Beam Distance···················· 2-11
Clutch Disc Wear ································· 2-11
Cushion················································· 2-11
Steering Handle···································· 2-12
Wheel/Tire············································· 2-12
Nuts, Bolts Tightness·························· 2-12
Special Tools List ································ 2-13
Precautions in Operation
Specification
Fuel Tank Capacity
17000±200c.c.
Capacity 3000 c.c.
Change 2400 c.c.
Engine Oil
Replace oil filter 2700 c.c.
Rear axle gear oil Capacity 100 c.c.
Front differential gear oil Capacity 200 c.c.
Engine + radiator 1750 c.c.
Capacity of coolant
Reservoir upper 350 c.c.
Clearance of throttle valve 1~3 mm
Type NGK CR8E
Spark plug
Gap 0.8 mm
“F” Mark in idling speed BTDC 10º / 1700 rpm
Full timing advanced BTDC 30º / 6000~7000 rpm
Idling speed 1700±100 rpm
Cylinder compression pressure 12.0 ±2 kgf/cm²
Valve clearance IN: 0.10 ± 0.02 mm EX: 0.15 ± 0.02 mm
Front AT25x8-12
Tire dimension
Rear AT25x10-12
Tire pressure (cold) 4.8±0.2 psi / 4.1±0.2 psi
Battery 12V10Ah (MF battery) type: GTX12-BS
Home page
Contents
2