16. STEERING / FRONT SUSPENSION
16-3
Steering Handle
Removal
Remove the handle cover, meter set, handle
protect cover and front fender. (Refer to chapter
13)
Remove the handle wire band.
Loosen the socket bolts from the rear brake
master cylinder, and remove front brake master
cylinder.
Caution
Do not let foreign materials enter the brake
master cylinder.
Remove 2 screws, and then remove throttle
hosing holder and throttle hosing.
Loosen 2 screws, and then remove handle left
switch and choke hosing.
Loosen 2 screws, and then remove 2&4 wheel
drive change switch.
Loosen the 2 socket bolts for the front brake
master cylinder, and remove front brake master
cylinder.
Caution
Do not let foreign materials enter the brake
master cylinder.
Loosen the 2 screws for throttle hosing holder and
remove throttle hosing.
To this chapter contents
2
2 screws
2 brocket bolts
Handle lift
Handle wire
2 brocket bolts
To Next Page
Loading...
