Tascam Sonicview 16 User Manual

6 – Modules
o If the module is stereo and output port that are not left-
right adjacent are selected, output port names will appear
split left and right and abbreviated as follows on the
Others button.
Module name
shown
Stereo module name
shown
ANALOG AN
Dante DA
SLOT 1 S1
SLOT 2 S2
USB OUT USB
o Tap the Others button to open the OUTPUT PORT SELECT
Screen. (See “OUTPUT PORT SELECT screen” on page
108.)
o The signal from a single module can be assigned to
multiple output ports.
3 LOCK/UNLOCK button
o This button locks/unlocks routing setting change
operations for the unit. This is always locked at the time of
start up.
o When set to “LOCK”, tapping the OUTPUT PORT selection
button (2) will not change settings. Furthermore, the
8ch BLOCK, 16ch BLOCK and BATCH SETUP buttons will
also be disabled. However, tapping the Others button and
switching to the OUTPUT PORT SELECT Screen is possible.
o When set to “LOCK”, tap this button to open a confirmation
message. Tap the UNLOCK button to close the message
and set it to “UNLOCK”. Tapping the CANCEL button on
the confirmation message will close it and maintain the
locked state.
o Tap this button when set to “UNLOCK” to switch it to
“LOCK”.
NOTE
The LOCK/UNLOCK button (1) setting is shared by the
following routing setting screens.
i MODULE (INPUT) Screen
i MODULE (OUTPUT) Screen
i INPUT SOURCE SELECT Screen
i OUTPUT PORT SELECT Screen
i DIRECT OUT PORT SELECT Screen
i INSERT SEND PORT SELECT Screen
i INSERT RETURN PORT SELECT Screen
4 POST FADER level meter(s)
This shows POST FADER signal level(s).
5 Stereo Link button (MIX 1–22 modules only)
o These show the stereo link setting states of the MIX1–22
modules.
Stereo linking is off
Stereo linking is on
o Tap this button to open the Stereo Link setting window.
Linking with either module to the left or right is possible
except for MIX 1 and MIX 22.
6 8ch BLOCK button (MIX 1–22 modules only)
When the LOCK/UNLOCK button (3) is set to “UNLOCK”, tap
this button to open a window where the output ports of 8
channels can be set at the same time. (See “Setting output
ports for multiple channels at the same time” on page 101.)
Change settings for multiple designated channels at the
same time.
7 16ch BLOCK button (MIX 1–16 modules only)
When the LOCK/UNLOCK button (3) is set to “UNLOCK”, tap
this button to open a window where the output ports of 16
channels can be set at the same time. (See “Setting output
ports for multiple channels at the same time” on page 101.)
Change settings for multiple designated channels at the
same time.
8 BATCH SETUP button
When the LOCK/UNLOCK button (3) is set to “UNLOCK”,
tap this button to open a BATCH SETUP window where the
output ports of a range of channels can be set at the same
time. (See “Setting output ports for multiple channels at the
same time in batches” on page 102.)
Change settings for multiple designated channels at the
same time.
TASCAM Sonicview 16/Sonicview 24 V1.1.0 145

Tascam Sonicview 16 Specifications

General

Brand	Tascam
Model	Sonicview 16
Category	Music Mixer
Language	English