Tascam Sonicview 16 User Manual

4 – Mixer configuration and settings
3 AUDIO/CLOCK setting status
This shows the status of Dante audio signal and clock.
Item Content
Sampling rate
This shows the sampling frequency
setting of the built-in Dante
module. Tap this area to open a
window where 48kHz or 96kHz can
be selected. (default: 96 kHz)
NOTE
If the sampling rate is 48kHz, 64 IN
and 64 OUT will be available. If it is
96kHz, this becomes 32 IN and 32
OUT.
Encoding This shows the encoding setting.
AES 67 Mode This shows the AES67 mode.
Latency
This shows the latency setting. Tap
this area to open a window where
the latency (0.25msec, 0.5msec,
1.0msec, 2.0msec or 5.0msec) can
be selected. (default: 1.0msec)
Clock Source
This shows the Dante module clock
source (Dante or Sonicview).
Dante Clock Status
This shows the Dante clock status
(Follower or Leader).
Preferred Leader
This shows the Preferred Leader
setting. Tap this area to open a
window where ON or OFF can be
selected. (default: OFF)
Controller Settings page
Use this page to make Dante network settings for SB-16D
control.
1 Control Network Settings
This shows the status of the Dante network settings for SB-
16D control.
Item Content
Addressing
This shows the IP address setting mode.
Tap this area to open a window where
AUTO (DHCP) or STATIC can be selected.
(default: AUTO (DHCP))
IP Address
If the Addressing item is set to “AUTO”,
this will show the assigned IP address. If
it is set to “STATIC”, this will show the IP
address set by the user.
When the Addressing item is set to
“STATIC”, tapping this area will open the
IP ADDRESS Screen. (See “IP Address/
Subnet Mask/Default Gateway setting
procedures” on page 91.)
Subnet mask
If the Addressing item is set to “AUTO”,
this will show the assigned subnet mask.
If it is set to “STATIC”, this will show the
subnet mask set by the user.
When the Addressing item is set to
“STATIC”, tapping this area will open the
SUBNET MASK Screen. (See “IP Address/
Subnet Mask/Default Gateway setting
procedures” on page 91.)
MAC Address
This shows the MAC address for SB-16D
control.
2 Routing control setting
This sets whether Dante routing settings are made on the
Sonicview or the Dante Controller.
Tap this area to open a window where “This console” and
“Dante Controller” can be selected.
Option Meaning
This console
(default)
SB-16D and Sonicview Dante routing
is set automatically according to the
SB-16D mounting status.
We recommend this when an SB-16D
is the only Dante device connected to
the Sonicview.
Dante Controller
Dante routing will not be set even if an
SB-16D is mounted.
Use Dante Controller for routing. Use
this setting when connecting Dante
devices other than an SB-16D.
TASCAM Sonicview 16/Sonicview 24 V1.1.0 59

Tascam Sonicview 16 Specifications

General

Brand	Tascam
Model	Sonicview 16
Category	Music Mixer
Language	English