2 – Names and Functions of Parts
Menu structure
The following is an overview of the various menu items.
Menu item Sub menu item Functions Page
Mixer Setup
Meter
View various meters and set various meter display
parameters
page 36
MIX Send Overview View and use a list of MIX 1–22 bus send settings page 149
Main L/R Assign Overview View and use a list of MAIN L/R bus assignment states page 154
DCA / Mute Group
Make the following settings
i DCA assignments
i Mute Group assignments
i Turn Mute Group Master on/off
page 158
Monitor / Solo Setup Make monitor output and solo function settings page 54
Talkback / OSC Setup Make talkback and built-in oscillator settings page 57
Mixer Config / Bus Config
Make the following settings
i CH 1–40 stereo link settings
i DIRECT OUT POINT settings
i DELAY POINT settings
i INSERT POINT unified settings
i BUS MODE settings
i MIX 1–22 stereo link settings
i Pan link settings
page 40
Front Panel Setup
User Key Setup Assign functions to the 18 USER KEYS page 47
Layer / Master Fader Setup
Make the following settings
i Assign channel sets and custom layers to the 7 LAYER
KEYS
i Assign module groups to custom layers
i Assign modules to the MASTER fader
page 50
Talkback Setup Make talkback settings page 57
Brightness Set the brightness of the various displays page 34
Rear Panel Setup
Dante Setup
Set and view the status of the built-in Dante module and an
SB-16D connected via the built-in Dante module
page 58
Slot Setup
Set various functions of expansion cards loaded in SLOT 1
and SLOT 2
page 88
WORD OUT Mode Setup Make WORD OUT jack output mode settings page 32
Network Setup Make Network settings page 90
FOOT SW Setup Assign footswitch functions page 48
GPIO Input Setup Assign functions to the GPIO input connector page 48
GPIO Output Setup Assign functions to the GPIO output connector page 49
LAMP Dimmer Setup
Set the brightness of the lamp connected to the LAMP jack
on the back of the unit
page 34
TASCAM Sonicview 16/Sonicview 24 V1.1.0 27
To Next Page
Loading...
Need help?
General
