6 – Modules
MODULE (INPUT) Screen
Set module input settings on the MODULE (INPUT) Screens for
CH 1–40 and ST IN 1–2 modules.
Tap the INPUT area on the Home Screen when the selection
frame is shown to open this screen.
CH 1–40 modules
CH 1–40 modules with Stereo Link on
ST IN 1–2 modules with input source set to ANALOG
1 INPUT level meter area
This shows the input signal level(s) of the selected module.
2 INPUT SOURCE buttons
o When the LOCK/UNLOCK button (3) is set to “UNLOCK”,
tap these buttons to select the input source of the
selected module.
Only the one button for the selected input source will be
highlighted.
o Buttons for Dante ports that have mounted SB-16Ds
assigned will be shown as “SB #[ID] [port number]”.
If it is a virtually-mounted SB-16D, will appear to the top
right.
o Assigned buttons for Dante ports that have virtually
mounted SB-16Ds will be highlighted yellow.
o If the selected input source is not shown by one of the
buttons on the screen, it will be shown on the Others
button.
o If the module is stereo and input sources that are not
left-right adjacent are selected, input source names will
appear split left and right and abbreviated as follows on
the Others button.
Module name
shown
Stereo module name
shown
ANALOG AN
Dante DA
SLOT 1 S1
SLOT 2 S2
USB IN USB
ST IN 1 ST1
ST IN 2 ST2
PLAYER PL
o Tap the Others button to open the INPUT SOURCE SELECT
Screen. (See “INPUT SOURCE SELECT screen” on page
102.)
124 TASCAM Sonicview 16/Sonicview 24 V1.1.0
To Next Page
Loading...
