4 – Mixer configuration and settings
MONITOR SOURCE ASSIGN screen
On this screen, assign monitoring sources for monitoring from
the front panel headphone jacks and the rear panel MONITOR
OUT L/R jacks to the 6 MONITOR SELECT buttons.
To open this screen, tap the icon in the MONITOR SELECT area
on the left side of the MONITOR/SOLO page of the MONITOR
SETUP screen.
1 MONITOR SELECT page switches
Monitoring sources can be assigned on each MONITOR
SELECT page separately.
The names of the assigned monitoring sources are shown on
the MONITOR SELECT page.
Tap this area to switch open MONITOR SELECT pages.
2 Monitoring source group page switches
These show monitor source group page names.
Tap a page name to switch to the page with the
corresponding monitoring sources.
The name of the selected page will be highlighted.
Page name Contents
MIX
MAIN L/R
Select output signals from MIX 1–22 and
MAIN L/R Master modules.
ST IN
PLAYER
Select input signals from the two pairs of ST
IN jacks and the internal player.
Dante
Select input signals from the Dante
connectors.
SLOT 1
Select the inputs of the expansion card
installed in SLOT 1.
SLOT 2
Select the inputs of the expansion card
installed in SLOT 2.
USB IN Select USB audio interface inputs.
3 Monitoring source assignment buttons
o Tap these buttons to select monitor sources to assign to
the selected MONITOR SELECT button. Assigned buttons
will be highlighted light blue. Assigned buttons for
Dante ports that have virtually-mounted SB-16Ds will be
highlighted yellow.
o Buttons for Dante ports that have mounted SB-16Ds
assigned will be shown as “SB #[ID] [port number]”. If it is a
virtually-mounted SB-16D, will appear to the top right.
56 TASCAM Sonicview 16/Sonicview 24 V1.1.0
To Next Page
Loading...
