6 – Modules
NOTE
i The underlined words in the menu item list will be replaced
with the MODULE screen names of the selected module.
i The menu items with underlined words are not shown on the
MODULE (OVERVIEW) and MODULE (OUTPUT) screens.
i The following parameters cannot be copied or pasted.
i Analog GANI*
i PAD*
i +48V*
i Input Routing*
i OSC Input*
i Output Port Assign**
i Insert Send Port Assign**
i Insert Return Port Assign**
i Insert ON/OFF**
i Direct Out Port Assign**
* Analog GAIN, PAD and +48V settings are assigned to MIC/
LINE input jacks rather than modules. Moreover, MIC/LINE
input jacks can be assigned as input sources for multiple
modules. These parameters are excluded from copying
and pasting because doing so would affect other modules
along with the paste destination.
** Output ports cannot be used by multiple modules at
the same time. These parameters are excluded from
copying and pasting because doing so would change the
output settings of other modules along with the paste
destination.
Pasting phase parameters
Phase parameters can be set independently for left and right
even for stereo modules.
If the mono/stereo states of the copy source and paste
destinations are different, the following will happen.
o If the copy source is a mono module and the paste
destination is a stereo module, the copy source phase data
will be pasted to Lφ and Rφ of the paste destination.
o If the copy source is a stereo module and the paste
destination is a mono module, the Lφ data of the copy source
will be pasted to the φ of the paste destination.
Pasting MODE/IMAGE parameters
MODE/IMAGE parameters shown on the MODULE (SEND/
PAN) screen only exist for stereo input modules. (See “MODULE
(SEND/PAN) Screen” on page 140.)
For this reason, MODE/IMAGE parameters can only be copied
and pasted when both the source and destination are stereo
input modules.
TASCAM Sonicview 16/Sonicview 24 V1.1.0 147
To Next Page
Loading...
