Technogym SYNCHRO Excite + - Page 140

SYNCHRO Excite +: Service & maintenance manual - rev. 7.1
Page 7.42
Figure 7.12-4
3. Remove the screw (d)
that is locking the bar
(e)
with a medium extractor, as shown in the
figure at the side.
Figure 7.12-5
Carry out the operations described in
paragraph: 7.7.3. “Front guard”.
4. Remove the plug (f) using a
small flat Phillip
screwdriver, on both the sides.
Figure 7.12-6
5. Back off the nut (g)
using a 17mm wrench,
locking the bolt on the opposite side with the
same wrench, as shown in the figure.
ATTENTION:
During reassembly
lock down the nut using a torque
wrench setting of 40Nm.
Continued in following page...