TECO e510 series - Page 106

4-32
(V) 100% is the maximum output voltage. B, C point preset % settings will be as table below:
 Setting 01-00 =[18] provides a flexible V/F curve which can be selected by experienced users by
setting parameters (01-02~01-09).
01- 01 V/F Max Voltage
Range
【200V:170.0~264.0, 400V: 323.0~528.0】V
01- 02
Base Frequency
Range
【0.20 ~ 599.00】Hz
01- 03
Maximum Frequency Voltage Ratio
Range
【0.0 ~ 100.0】%
01- 04
Medium Frequency 2
Range
【0.10 ~ 599.00】Hz
01- 05
Medium Frequency Voltage Ratio 2
Range
【0.0 ~ 100.0】%
01- 06
Medium Frequency 1
Range
【0.10 ~ 599.00】Hz
01- 07
Medium Frequency Voltage Ratio 1
Range
【0.0 ~ 100.0】%
01- 08
Minimum Frequency
Range
【0.10 ~ 599.00】Hz
01- 09
Minimum Frequency Voltage Ratio
Range
【0.0 ~ 100.0】%
 Base frequency depends on parameter 01-00 , for 01-00=【18】 It can be set by parameter 01-02.
 For 01-00 ≠【18】, the Base frequency will depending on parameter 00-12, frequency upper limit.
01- 00 B(Xb) C(Xc)
0 / 9 7.5% 4.5%
1 / 10 10.0% 7.0%
2 11.0% 8.5%
3 12.0% 9.5%
4 17.5% 4.0%
5 25.0% 5.0%
11 11.0% 8.0%
12 12.0% 9.0%
13 20.5% 7.0%
14 28.5% 8.0%
6 / 15 45.0% 1.0%
7 / 16 55.0% 1.0%
8 / 17 65.0% 1.0%