TECO e510 series - UL Standards; UL Standards Compliance; Main Circuit Terminal Wiring

Appendix-1 Instructions for UL
◆ UL Standards
The UL/cUL mark applies to products in the United States and Canada and it means that UL has performed product testing and evaluation and
determined that their stringent standards for product safety have been met. For a product to receive UL certification, all components inside that
product must also receive UL certification.
◆ UL Standards Compliance
This drive is tested in accordance with UL standard UL508C and complies with UL requirements. To ensure continued compliance when using this
drive in combination with other equipment, meet the following conditions:
■ Installation Area
Do not install the drive to an area greater than pollution severity 2 (UL standard).
■ Main Circuit Terminal Wiring
UL approval requires crimp terminals when wiring the drive’s main circuit terminals. Use crimping tools as specified by the crimp terminal
manufacturer. Teco recommends crimp terminals made by NICHIFU for the insulation cap.
The table below matches drives models with crimp terminals and insulation caps. Orders can be placed with a Teco representative or directly
with the Teco sales department.
Closed-Loop Crimp Terminal Size
Do not modify the drive circuitry.
Failure to comply could result in damage to the drive and will void warranty.
Teco is not responsible for any modification of the product made by the user. This product must not be modified.
Check all the wiring to ensure that all connections are correct after installing the drive and connecting any other devices.
Failure to comply could result in damage to the drive.
UL/cUL Mark
Drive Model
E510
2
Terminal Crimp Terminal Tool Insulation Cap
R/L1 x S/L2 x T/L3 U/T1 x V/T2 x W/T3 Screws Model No. Machine No. Model No.
NOTICE
SICP_C710616_28B_1_0.book Page 550 Wednesday, May 13, 2009 4:50 PM
202
202-H3
205
210
220
402
405
415
425
R2-3.5
R2-3.5
R8-5
M3.5
M4
M5
21.2 (4)
2.1 (14)
2.1 (14)
8.4 (8)
Nichifu NH 1 / 9
Nichifu NH 1 / 9
Nichifu NH 1 / 9
Nichifu NOP 150H TIC 22
TIC 2
TIC 2
TIC 8
2.1 (14)
8.4 (8)
M5
R8-5
R2-3.5
Nichifu NH 1 / 9 TIC 8
Nichifu NH 1 / 9 TIC 2
R3.5-4
R
2-3.5
R5.5-4
M4
M3.5
M4
3.3 (12)
2.1 (14)
5.3 (10)
Nichifu NH 1 / 9
Nichifu NH 1 / 9
Nichifu NH 1 / 9
TIC 3.5
TIC 2
TIC 5.5
8.4 (8)
M5
R8-5
Nichifu NH 1 / 9 TIC 8
201
M3.5
M5 R22-5
Wire Gauge
(min)
mm (AWG
)