TECO e510 series - Chapter 4 Software Index; 4.1 Keypad Description

4-1
Chapter 4 Software Index
4.1 Keypad Description
4.1.1 Operator Panel Functions
Type Item Function
Digital
display &
LEDs
Main digital displays
Frequency Display, Parameter, voltage, Current,
Temperature, Fault messages.
LED Status
Hz/RPM: ON when the frequency or line speed is displayed.
OFF when the parameters are displayed.
FWD: ON while the inverter is running forward. Flashes
while stopped.
REV: ON while the inverter is running reverse. Flashes
while stopped.
FUN: ON when the parameters are displayed. OFF when
the frequency is displayed.
Variable
Resistor
FREQ SET Used to set the frequency
Keys
On
Keypad
(8
buttons)
RUN RUN: Run at the set frequency.
STOP STOP: Decelerate or Coast to Stop.
▲ Increment parameter number and preset Values.
▼ Decrement parameter number and preset Values.
FWD/REV
(Dual function keys)
FWD: Forward Run
REV: Reverse Run
DSP/FUN
(Dual function keys)
DSP: Switch between available displays
FUN: Used to examine the parameter content
READ/ENTER
(Dual function keys)
READ:ENTER:
Used to display the preset Value of parameters and for saving
the changed parameter Values.
</ RESET
(Dual function keys)
“<”Left Shift: used while changing the parameters or
parameter Values
RESET: Use to Reset alarms or resettable faults