4-8
4.2 Programmable Parameter Groups
Parameter Group No. Description
Group 00 Basic Parameters
Group 01 V/F Pattern Selections and Setup
Group 02 Motor Parameters
Group 03 Multi Function Digital Inputs/Outputs
Group 04 Analog Signal Inputs/Output
Group 05 Preset Frequency Selections
Group 06 Auto Run Function(Auto Sequencer)
Group 07 Start/Stop Command Setup
Group 08 Drive and Motor Protection
Group 09 Communication Function Setup
Group 10 PID Function Setup
Group 11 Performance Control Functions
Group 12 Digital Display & Monitor Functions
Group 13 Inspection & Maintenance Functions
Group 14 PLC Setting Function
Group 15 PLC Monitoring Function
Parameter notes for Parameter Groups
*1 Parameter can be adjusted during running mode
*2 Cannot be modified in communication mode
*3 Does not change with factory reset
*4 Read only
*5 Available for above V1.1
*6 Available for above V1.3
*7 Available for above V1.7
To Next Page
Loading...
