TECO e510 series - MUL- DIV Module

4- 91
6. MUL- DIV module
symbo Description

Calculation results RESULT

multiplierA(AS1~AS4,MD1~MD4,
T1~T8,C1~C8,V1~V7, constant)

multiplierB
(AS1~AS4,MD1~MD4,T1~T8,C1~
C8,V1~V7, constant)

divisor
(AS1~AS4,MD1~MD4,T1~T8,C1~
C8,V1~V7, constant)

Error signal coil output（NOP
/
M1~MF）

Instruction code of MUL- DIV
module
RESULT =V1*V2/V3
Sample:
I1 (MD1)
（Q1）
ON/OFF of I1 controls the Run /Stop
status of MD1
5014
345
654
45
MD1
M1
M1 is coil error，if the RESULT is more than the
upper limit(65535) or Below the lower limit
（0） ,M1 is ON,Q1 is ON
Input under the Function
Program Mode
Input under the Ladder Program Mode
The RESULT of MD1(Note:if the RESULT is more
than 65535,Here can only display 65535;similarly,if
the RESULT is less than the lower limit of 0 )
Multiplier value of V1
Multiplier value of V2
Multiplier value of V3
Instruction code of MUL- DIV
module（MD1~MD4）
（M1）
5
6
2
1
3
4