TECO e510 series - Inspection & Maintenance Functions

4-25
Group 12 Digital Display & Monitor Functions
No. Description Range
Factory
Setting
Unit Note
12-07
Detect Main Circuit
Capacitors
Reserved
12-08
Display of Inrush Current
Suppression Circuit
0~100 100 %
12-09
Display of Control Circuit
Capacitors
0~100 100 %
12-10
Reserved
12-11
Output Current when
Fault Appeared
---- 0 A
12-12
Output Voltage when
Fault Appeared
---- 0 Vac
12-13
Output Frequency when
Fault Appeared
---- 0 Hz
12-14
DC Bus Voltage when
Fault Appeared
---- 0 Vac
12-15
Frequency Command when
Fault Appeared
---- 0 Hz
Group 13 Inspection & Maintenance Functions
No. Description Range
Factory
Setting
unit Note
13-00
Drive Horsepower Code ---- - - *3
13-01
Software Version ---- - - *3*4
13-02
Fault Log (Latest 3
Faults)
---- - - *3*4
13-03
Accumulated Inverter
Operation Time 1
0~23 - hour *3
13-04
Accumulated Inverter
Operation Time 2
0~65535 ---- day *3
13-05
Accumulated Inverter
Operation Time Mode
0: Power On time
1: Operation time
0 - *3
13-06
Parameter Lock
0:Enable all Functions
1:Preset Speeds from 05-01 to 05-15 Can’t be
Changed
2:All Functions Can’t be Changed Except
for Preset speeds from 05-01 to 05-15
3:Disable All Functions Except 13-06
0 -
13-07
Parameter Lock Code 00000~65535 00000 -
13-08
Reset Drive to Factory
Settings
1150: Reset to factory setting. 50Hz,220V/380V
system.
1160: Reset to factory setting. 60Hz,220V/380V
system.
1250: Reset to factory setting 50Hz,230V/400V
system.
1260: Reset to factory setting 60Hz,230V/460V
system.
1350: Reset to factory setting 50Hz,220V/415V
system.
1360: Reset to factory setting 60Hz,230V/400V
system.
1112: Reset PLC
00000 -