4-21
Group 08- Drive & Motor Protection Functions
No. Description Range
Factory
Setting
Unit Note
08-13
Over Torque Detection
Control
0: Over Torque Detection Disabled
0 -
1: Over torque detection after set frequency is
reached
2: Over torque detection after run command
08-14
Over torque protection
action
0: Stop Output After Over Torque Detection
(Free Run to Stop)
0 -
1: Continue Running After Over Torque
Detection (Display only OL3)
08-15
Over Torque Detection
Level
30~300 160 -
08-16
Over Torque Detection
Time
0.0~25.0 0.1 -
08-17
Fire Mode (for firmware
below v1.1)
0: Disable
0 -
1: Enable
08-18
Ground Fault Detection
0: Disable
0 *7
1: Enable
Notes: Regarding fire mode function, please refer to the conditions below,
1. Below firmware v1.1, Fire Mode is enabled by setting 08-17 = 1
2. Above (including) firmware v1.1, Fire Mode is enabled by setting digital inputs 03-00~03-05 = 28.
Parameter 08-17 is then removed.
3. 08-18 is applicable to frame 3 and 4 only.
Group 09- Communication function setup
No. Description Range
Factory
Setting
Unit Note
09-00
Assigned Communication
Station Number
1 ~ 32 1 - *2*3
09-01
RTU/ASCII Code Selection
0:RTU Code
1:ASCII Code
0 - *2*3
09-02
Baud Rate Setting (bps)
0:4800
1:9600
2:19200
3:38400
2 bps *2*3
09-03
Stop Bit Selection
0:1 Stop Bit
1:2 Stop Bits
0 - *2*3
09-04
Parity Selection
0:Without Parity
1:With Even Parity
2:With Odd Parity
0 - *2*3
09-05
Data Format Selection
0: 8-Bits Data
1: 7-Bits Data
0 - *2*3
09-06
Communication Time-Out
Detection Time
0.0 ~ 25.5
0.0 Sec
09-07
Communication Time Out
Operation Selection
0:Deceleration to Stop
(00-15: Deceleration Time 1)
1:Coast to Stop
2:Deceleration to Stop
(00-17: Deceleration Time 2)
3:Continue Operating
0 -
09-08
Comm. Fault Tolerance Count. 1 ~ 20
3
09-09
Wait Time of Inverter
Transmission
5 ~ 65
5 ms
To Next Page
Loading...
