TECO e510 series - Digital Display Setup; User Selectable Display Formats

4-4
4.1.3 Digital display set up
On power up digital display screens will be as shown below.
2sec later
Power supply
frequency
parameter
DSP/
FUN
DSP/
FUN
User selectable display formats:
12- 00 Display Mode
Range
0 0 0 0 0
High
Low
Each of the above 5 digits can be set to any of the selections below from 0 to 8
【0】:Disable display 【1】:output Current
【2】:output Voltage 【3】:DC voltage
【4】:Temperature 【5】:PID feedback
【6】:AI1 【7】:AI2 【8】:count Value
The highest bit of 12-00 sets the power on the display, other bits set the selected display from range 0-7.as
listed above.
Example1: Set parameter 12- 00=【10000】to obtain display format shown below.
2sec later
display：Power supply
Output Current
Set frequency
parameter
DSP/
FUN
DSP/
FUN
DSP/
FUN